CrewDesk

CrewDesk/Free tools/Footage Transfer Time

Free tool for film and video productionFootage transfer time calculator

Enter the footage size, your measured transfer speed and the number of sequential copies. Get an estimated time for one copy and for the full batch, plus throughput per hour.

Time for one copy17 min
Time for all copies33 min
Transfer throughput360.0 GB/h

The result updates as you type. Every starting value is an example: put in your own.

How the estimate works

The calculator converts the file size to megabytes and divides it by your measured speed. It multiplies the one-copy time by the number of sequential copies.

Throughput per hour converts your entered speed to gigabytes per hour. The calculation uses 1 GB = 1,000 MB and 1 hour = 3,600 seconds.

Get a useful estimate

Measure the speed with a similar drive, connection and set of files, then enter that result. Speed can vary during a transfer, so a measurement from your setup is more useful than a peak figure.

What this leaves out

The estimate assumes each copy runs one after another at a steady speed. It does not include verification, setup time, interruptions or other activity that may affect the transfer.

Questions

Asked before the first call

How do I find my transfer speed?

Measure a transfer using a similar setup and enter the observed speed. Results can vary with drives, connections and files.

Are copies treated as sequential?

Yes. The total assumes each copy starts after the previous one finishes.

Why use 1,000 MB per GB?

This calculator uses decimal units: 1 GB equals 1,000 MB. Check how your storage or transfer tool reports file sizes if you need a closer comparison.

Does the estimate include verification?

No. Add time separately for verification, setup, interruptions or other steps in your workflow.

● Rolling

See it run.

CrewDesk is a working application, not a mock-up. Open it, move a project to the next stage, assign a task, and judge it on what it does.